Table of Contents
Advertisement
Figure 10
1. Reel-drive motor
2
Adjusting the Turf
Compensation Spring
No Parts Required
Procedure
The turf compensation spring
from the front to the rear roller. This helps to reduce a wave
pattern in the turf, also known as marcelling or bobbing.
Important: Make spring adjustments with the cutting
unit mounted to the traction unit, pointing straight
ahead and lowered to the shop floor.
1. Make sure that the hairpin cotter is installed in the rear
hole in the spring rod
2. Mounting nuts
(Figure
11) transfers weight
(Figure
11).
1. Turf compensation spring
2. Hairpin cotter
2. Tighten the hex nuts on the front end of the spring
rod until the compressed length of the spring
11) is 12.7 cm (5 inches).
Note: When operating on rough terrain, decrease the
spring length by 2.5 cm (1/2 inch). Ground following
will be slightly decreased.
3
Installing the CE Decal
Parts needed for this procedure:
1
Warning decal (120-1686)
Procedure
If this machine will be used for CE, affix the warning decal
120-1686 over English warning decal 120-1683.
15
g020164
Figure 11
3. Spring rod
4. Hex nuts
(Figure
Advertisement
Table of Contents
