Philips SC2000/00 User Manual page 20

EngliSh
0
Problem
The 'ready to flash' light
does not go on when
I place the removable
window on my skin, but
the cooling fan works.
The 'ready to flash' light is
green but the appliance
does not produce a flash
when I press the flash
button.
The appliance becomes
warm during use.
The appliance does not
show light intensity 1
when I switch it on.
The appliance produces
a strange smell.
The treatment is more
perceptible than usual.
Possible cause
The overheat
protection has been
activated.
The appliance needs to
be reset.
This is normal.
The appliance needs to
be reset.
The removable
window is dirty.
You have not shaved
the area to be treated
properly.
You used a too high
light intensity.
You did not shave the
areas to be treated.
The appliance is
defective.
You stored the
appliance in a dusty
environment.
The filter glass in the
light exit window is
broken.
Solution
When the overheat protection has been activated,
the fan still works. Do not switch off the appliance
and let it cool down for approx. 15 minutes before
you continue to use it. If the 'ready to flash' light
still does not go on when you place the appliance
on the skin, contact the Consumer Care Centre
in your country, your Philips dealer or a Philips
service centre.
To reset the appliance, switch off the appliance
and switch it on again. If the 'ready to flash' light
is green but the appliance still does not produce
a flash when you press the flash button, contact
the Consumer Care Centre in your country, your
Philips dealer or a Philips service centre.
No action required.
To reset the appliance, switch it off and on again.
If the appliance still does not show light intensity
1, contact your Customer Care Centre, your
Philips dealer or a Philips Service Centre.
Clean the removable window carefully. If you
are unable to clean the removable window
properly, contact the Consumer Care Centre
in your country, your Philips dealer or a Philips
service centre to replace the removable window.
If there are hairs on the area to be treated, these
hairs may get burnt when you use the appliance.
As a result, you notice a strange smell. Shave the
area to be treated properly before you use the
appliance.
Check if you have selected the right light intensity.
If necessary, select a lower light intensity.
Always shave the areas to be treated before you
use the appliance.
Contact the Consumer Care Centre in your
country, your Philips dealer or a Philips service
centre.
The strange smell disappears after a few flashes.
If the filter glass in the light exit window is broken,
do not use the appliance anymore. Contact the
Consumer Care Centre in your country, your
Philips dealer or a Philips service centre.