How To Achieve Optimal Results - Philips SC2000/00 User Manual

Philips photo-epilator sc2000 with ipl technology
Hide thumbs Also See for SC2000/00:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Area
One full leg
Approx. number of flashes
320-380
Note: Fully charged batteries offer at least 160 flashes at intensity 5, which
amounts to a cordless operating time of approx. 15 minutes.

how to achieve optimal results

Optimal results cannot be obtained with a single session, since only hairs
in the anagen phase are susceptible to treatment with light. During a
treatment, hairs on a treated area are usually in different stages of the cycle
of hair growth. To treat all hairs successfully and to prevent that the hair
root becomes active again, you have to repeat the treatment every 2
weeks. It is recommended to adhere to this frequency. Better results are
not expected if you increase or decrease the treatment frequency. Clinical
trials have shown that this is the optimal frequency of use.
after treatment
after treatment it may happen that:
-
Your skin shows slight redness and/or prickles, tingles or feels warm.
This reaction is harmless and disappears quickly.
-
A skin reaction similar to sunburn may occur on the treated area for a
short while.
-
Your skin may appear to be dry, as the combination of shaving and light
treatment may cause dry skin.
-
Some hairs grow back although you use the appliance frequently.
This happens because hairs are in different stages of the cycle of hair
growth during treatment. The hairs that grow back tend to be softer
and thinner.
it is recommended to:
-
Consult your doctor if skin irritation does not disappear within three
days (see chapter 'Important', section 'Caution').
-
Wait with the next treatment until skin irritation has disappeared
completely. Perhaps you have used an intensity that was too high for
you. Use a lower intensity the next time.
-
Do not take an intensive sunbath or suntan without proper protection
immediately after a treatment. If you want to go sunbathing after a
treatment, apply a sun blocker to the treated areas.
-
Avoid swimming in chlorinated water for 48 hours after treatment.The
chlorine in the water can cause itchiness.
-
Avoid applying any cosmetic substances to the treated areas
immediately after treatment.
Cleaning and maintenance
Never clean the appliance or any of its parts under the tap or in the
dishwasher.
Never use scouring pads, abrasive cleaning agents or aggressive liquids
such as petrol or acetone to clean the appliance.
Never scratch the filter glass or the metallic surface inside the
removable window.
EngliSh
Approx. treatment time
30 minutes
15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sc2000

Table of Contents