Setting The Router Id For The Configuration - Peak PCAN-Router Pro User Manual

PCAN-Router Pro – User Manual
3.3 Setting the Router ID for the
Configuration
The board of the PCAN-Router Pro has a rotary switch with 16
settings to determine the Router ID (0 - F hex = 0 - 15).
When the PCAN-Router Pro is started with the standard firmware,
that configuration is loaded from the internal memory whose num-
ber matches the specified Router ID. In addition, the Router ID gives
the PCAN-Router Pro a unique identification during the PPCAN com-
munication (configuration transfer). For the transmission of CAN
messages during normal operation this Router ID is not relevant.
Note: The rotary switch setting "F" is reserved for an upload of
new firmware (start of the bootloader) on the PCAN-Router Pro
with a serial number of 100 and above.
This is how you change the Router ID of a PCAN-Router Pro:
1. Change the position of the rotary switch with a small slot
screwdriver.
Position of the rotary switch for the Router ID
16