Pstn Settings - jablotron JA-101K Manual

IP address – setting for manual IP address assignment that is only available if automatic assignment from
the DHCP server is not enabled. The default setting is 192.168.1.99
Subnet mask – setting for manual subnet mask IP assignment that is only available if automatic assignment
from the DHCP server is not enabled. The default setting is 255.255.255.0
Gateway – setting for manual default gateway IP
assignment that is only available if automatic assignment
from the DHCP server is not enabled. The default setting is
192.168.1.1
DNS server – setting for manual DNS server IP assignment
that is only available if automatic assignment from the DHCP
server is not enabled. The default setting is 192.168.1.1
Name – device name for easier identification in the local
network
MAC address – unique address of every LAN device
(identification of data source)
LAN device for identification of the source of information
Test DNS – when the LAN communicator is connected to the
Internet, the settings can be tested for correctness. If a green
dot appears after pressing of the button, the connection to the server has been established, but if a red dot
is displayed after a few seconds, the time for establishing the connection has expired, which indicates
an incorrect setting or an error in the LAN communicator connection.
10.11.3

PSTN Settings

It is used to set the phone communicator (if the control panel contains one).
PSTN Module – possibility to enable or disable
communication over a phone line.
Call limit min./day – limits the range of actual
calling from 5 to 250 minutes a day.
Remote control
the possibility to control the system remotely using
the voice menu. If Users are selected, the menu can
only be accessed from the phones of defined users
(in the Communication tab you can even allow users
to enter the voice menu without entering their user
code – the Voice menu without code option).
If Anybody is selected, the voice menu can
be accessed from any phone. However, on accessing
the menu the user is always requested to enter
the user's code.
Generated DTMF level (for ARC) – setting
the intensity of the transmitted tone dialling signal
in DTMF generated by the control panel. The intensity
is adjustable in 10 steps; the optimum default value
is 4.
DTMF detection sensitivity (from ARC) – setting the sensitivity of reception of the signal generated
by the alarm receiving centre. The sensitivity is adjustable in 10 steps; the optimum default value is 4.
Number of incoming call rings – number of ringing impulses until the call is answered by the communicator.
Answering can be set after 1 to 10 ringing impulses (corresponding from 5 to 50 seconds). The default value
is 3 (15 seconds).
PSTN access prefix – code for dialling through the internal phone exchange
Dial tone – if this parameter is off, the communicator will start dialling the set phone number regardless
of the type or presence of dialling tone. If it is on, the communicator will not start working until it detects
the dialling tone (e.g. dialling tone assignment delay in some phone exchanges)
Detection of busy tone – if the communicator detects the engaged tone, e.g. in a parallel line, it will hang up
and inform the system. You are not recommended to enable this parameter as the communicator
does not detect hanging up.
JA-101K(-LAN)(-LAN3G) and JA-106K(-3G)
Security System Control Panels
via telephone – setting
86 / 110 MLJ51410