Disabling And Blocking Options; Disabling; Blocking - jablotron JA-101K Manual

Limitation is valid for User authorisation only. If the user with enabled time limitation tries to unset a section in
the blocking period, the system will refuse it. And if the user was already inside the protected premises then
after entrance delay time expiration an intrusion alarm would be triggered. The user has authorization to cancel
the alarm but the system won´t be unset within the blocking period.
In the following example there is a variant of settings for access allowed for a selected group of users
"Access 1" where access is limited to Section 1. On Monday and Tuesday access is allowed from 5:00 in the
morning to 20:59 in the evening. From Wednesday to Friday access is allowed from 5:00 to 11:59 and then from
14:00 to 20:00 hrs. On the weekend (Saturday and Sunday) access is blocked completely.
To program time limited access using F-Link SW on the Users tab, the same name of the button which serves
for setting the group of users for individual sections is used.

9.16 Disabling and blocking options

9.16.1 Disabling

Before you set the system a situation can occur where a device is necessary to be intentionally bypassed from
guarding (for instance a garage because of some construction activity or leaving a dog inside a usually
protected room). This option is called Device disabling, it is available in an LCD keypad menu or by J-Link
software and it can be performed at two levels according to user authorization:
1. Blocking of input (BLK) – the function is for blocking a detector input (it blocks its activation). The system
ignores any detector activation = an alarm is not triggered, nor reports PG activation. Tamper alarms, faults
or low battery reports are supervised all the time. In the J-Link software it is indicated by a yellow dot.
Authorization for blocking to be performed belong to the Administrator and Service technician.
2. Device disabling (DIS) – this function is for disabling a detector. The system ignores all device functions
= it doesn´t trigger any alarms nor tamper alarms, reports or faults. In the J-link software it is indicated
by red dot. Authorization for disabling is done by the Service technician only.
Not only a device but also a section can be Disabled but only one without the control panel, also applies
to users except position 0 (service technician) and 1 (Administrator), PG outputs or calendar actions.
Disabling is permanent until it cancelled by the same procedure as its activation.
Caution: It is not possible to block or disable a control panel or a device with a Panic reaction!

9.16.2 Blocking

During section setting a situation can occur that some devices stay active (for example an open window
or a balcony door, flooded detector in a cellar, etc.). The system reacts to this situation quickly during the setting
of the section and informs about it, but after the confirmation the system will behave according to the parameter
Blocking during setting one of the following ways:
1. Blocking enabled – Enabling this option will make all active detectors blocked during setting, it means
they cannot trigger an alarm at all in this setting period.
2. Blocking disabled – Disabling this option will make all active detectors temporarily bypassed during
setting only, it means that if they go back to standby then they can trigger an alarm (there is the risk of false
alarm creation because of windows opened by draft for instance).
JA-101K(-LAN)(-LAN3G) and JA-106K(-3G)
Security System Control Panels 55 / 110 MLJ51410