Communication Between The Gas Analyzer And The Computer - ABB EasyLine Series Instructions For Installation Start-Up And Operation

Communication between the Gas Analyzer and the Computer

Communication via Ethernet
Setting up the communication between the gas analyzer and the computer
Check the TCP/IP parameters in the gas analyzer and the computer
Communication between the gas analyzer and the computer is executed
via an Ethernet connection, either as a point-to-point connection or via a
network.
The Ethernet connection enables communication

with the test and calibration software TCT-light,

with the configuration software ECT,

for transmission of the QAL3 data, if the option QAL3 monitoring has
been integrated in the gas analyzer,

for reading the measured values and for calibrating and controlling
the gas analyzer via the Modbus TCP/IP protocol.
NOTE
Detailed information on "Modbus" can be found in the technical
information "EL3000 Modbus" and "EL3010-C – Modbus via TCP/IP".
Basically, the following steps are required to set up the communication
between the gas analyzer and computer:
1 Check and set the TCP/IP parameters in the gas analyzer and the
computer.
2 Establish and test the Ethernet connection.
3 Start the communication between the gas analyzer and the computer.
The TCP/IP parameters in the gas analyzer and the computer must be
checked and changed if necessary for operation of the configurator. In
the case of a point-to-point connection, the IP addresses in the gas
analyzer and the computer must be carefully matched.
Example: gas analyzer: 192.168.1.4, computer: 192.168.1.2
Operating the Gas Analyzer 107