Notes On The Concept Of Operation - ABB EasyLine Series Instructions For Installation Start-Up And Operation

Notes on the Concept of Operation

Concept of Operation
Overview of the functions
Function
Automatic calibration:
Start/cancel automatic calibration (also possible via digital
inputs)
Activate/deactivate cyclically time-controlled automatic
calibration
Cycle time of the automatic calibration
End-point calibration together with zero-point calibration
Date and time of the next automatic calibration (start of the
cycle)
Test gas concentration
Purging times
Output current response (for automatic and manual
calibration)
Calibration method (Magnos206)
Pump on during calibration
Manual calibration:
Calibration method
Test gas concentration
Execute calibration (see page 113)
Maintenance functions:
Pump control
Calibration reset
Calibration of the pressure sensor / Setting the air pressure
value
Measuring the calibration cell (Uras26)
Drift, delta drift (display)
Software version
Status information (see page 122)
The concept of operation of the gas analyzers is designed in such a way
that the functions required in normal operation are operated and
configured directly on the instrument. On the other hand, the functions
which are only seldom required, e.g. during the commissioning of the
instrument, are configured offline using the software tool ECT ("EasyLine
Configuration Tool" on the enclosed CD-ROM, also referred to as
"configurator" in this manual) and then loaded into the gas analyzer.
Operating the Gas Analyzer
Instrument Configurator Modbus
X
X X
X
X
X X
X X
X X
X
X X
X
X X
X X
X
X X
X
X
X
X
X X
X
105
X
X
X
X
X
X