General Safety Precautions; El6010 Gas Analyzer; Follow Safety Precautions - ABB EL6010 Operator's Manual

General Safety Precautions

Requirements for
Safe Operation
Personnel
Qualifications
Special Information
and Precautions
National Regulations

EL6010 Gas Analyzer

Safety and Safe
Operation
Additional
Information
6
In order to operate in a safe and efficient manner, the EL6010 gas analyzer should
be properly handled and stored, correctly installed and set-up, properly operated
and carefully maintained.
Only persons familiar with the installation, set-up, operation and maintenance of
comparable equipment and certified as being capable of such work should work
on the EL6010 gas analyzer.
These include
• The content of this operator's manual.
• The safety information affixed to the EL6010 gas analyzer.
• Safety precautions for the installation and operation of electrical devices.
• Safety precautions for working with gases, acids, condensates, etc.
• Regulations, standards and guidelines for explosion protection.
The regulations, standards and guidelines cited in this operator's manual are
applicable in the Federal Republic of Germany. The applicable national regulations
should be followed when the EL6010 gas analyzer is used in other countries.
The EL6010 gas analyzer is designed and tested in accordance with EN 60950 :
1992 / A11:1997, "Safety of Information Technology Equipment" and has been
shipped ready for safe operation.
To maintain this condition and to assure safe operation, read and follow the safety
information identified with the
can put persons at risk and can lead to EL6010 gas analyzer damage as well as
damage to other systems and instruments.
If the information in this operator's manual does not cover a particular situation,
ABB Service is prepared to supply additional information as needed.
Contact your local ABB service representative or
ABB Service, Telephone: +49-1 80-5-12 35 80, Fax: +49-6 21-3 81-51 35,
E-mail: callcenter.automation@de.abb.com
EL6010 Gas Analyzer in Category 2G Operator's Manual
symbol in this operator's manual. Failure to do so
42/24-30 EN Rev. 1