Colormax Setting - Digital Projection M-Vision 18K Series Installation And Quick Start Manual

Digital Projection M-Vision Laser 18K Series
Setup menu continued from previous page

ColorMax Setting

ColorMax Setting

permits seven point
color matching of red, green, blue,
yellow, cyan, magenta and white.
You can enter your own gamut values
here, or edit values you have imported
using the Projector Controller
software.
Defi ning your own colorspace with
individual x and y coordinates for each
color enables you to match not only the
whites but each individual color as well.
Highlight the submenu you wish to
open and press ENTER/OK to confi rm
your choice.
Measured Data / Target Data
UP DOWN
1. Use the and arrow
buttons to highlight a color, then
LEFT RIGHT
use the and
x
arrow buttons to navigate to the
y
or coordinate.
UP DOWN
2. Use the and arrow
buttons to increase and decrease
the value, respectively.
3. Exit edit mode:
•
ENTER/OK
press , if you want
to save the edited values.
•
EXIT
press , if you do not wish
to save the edited values
4. If necessary, highlight another color
and repeat the procedure.
Operating Guide
USING THE PROJECTOR
Measured Data
Red x: 0.658 y: 0.339
Green x: 0.315 y: 0.662
Blue x: 0.146 y: 0.043
White x: 0.276 y: 0.283
Reset
ColorMax
Measured Data
Target Data – User 1
Target Data – User 2
Target Data – User 1
Red x: 0.640 y: 0.390
Green x: 0.300 y: 0.600
Blue x: 0.150 y: 0.060
Yellow x: 0.419 y: 0.505
Cyan x: 0.225 y: 0.329
Magenta x: 0.321 y: 0.154
White x: 0.285 y: 0.302
Notes
The Projector Controller software
is available for download from the
Digital Projection website, free of
charge.
This tool is best used in conjunction
with a specialized light meter (a
photo spectrometer) to measure
color parameters within a particular
installation. However, the preloaded
generic factory default data set
is designed to give more than
satisfactory results.
Rev D October 2019
page 69