3D Types - Digital Projection M-Vision 18K Series Installation And Quick Start Manual

Digital Projection M-Vision Laser 18K Series
3D menu continued from previous page

3D types

Auto
In most situations you can use the
help you set up the 3D input manually.
The following 3D formats are supported:
•
Dual Pipe (LEFT and RIGHT)
The left and right eye images are delivered on two separate HDMI links, which the projector will interleave for 3D display.
•
Frame Sequential
Displayport and HDMI inputs can accept Frame Sequential formats where both left and right eye images are delivered on a single cable.
Up to 120Hz can be received and displayed. Frames rates of 50Hz or 60Hz will be displayed at 100Hz or 120Hz respectively.
.
For sequential 3D, an external sync is required to identify left and right frames. If no sync is available from the sequential source, the
projector will generate an output sync, but it may then be necessary to manually reset the dominance each time the player is started.
L
Operating Guide
setting to have the projector automatically detect the format. Otherwise, consider the notes below to
L
HDMI 1
R
HDMI 2
Dual Pipe
R L
Frame Sequential
USING THE PROJECTOR
R
Notes
Processing through the projector
is limited 60Hz. Therefore while
120Hz sequential or Dual Pipe can
be accepted and displayed it will
drop to 60Hz for processing and
then frame double after processing.
Rev D October 2019
page 63