Table of Contents
Advertisement
2
Installing the Rinse Tank
Bulkhead Fitting
Parts needed for this procedure:
1
Rinse tank
1
Filler cap
1
Bulkhead fitting
1
Clear gasket
1
Plastic flange nut
1
90° fitting
1
Retaining fork
Procedure
1. Locate the rinse tank and filler cap, and the bulkhead
fitting in the bag of loose parts.
2. Install the bulkhead fitting into the hole at the bottom
of the rinse tank as follows:
A. Install a clear gasket onto the bulkhead fitting.
B. Attach a wire, longer than the tank is tall, to one
of the retaining fork holes in the bulkhead fitting
(Figure
2).
2
1
6
1. Rinse tank
2. Filler cap
3. Bulkhead fitting
C. Remove the rinse tank filler cap
D. Lower the wire through the opening in the tank
fill hole and route it through the open hole at the
bottom of the tank
E. Use the wire to guide the bulkhead fitting to the
open hole at the bottom of the tank
3
4
5
G014228
Figure 2
4. Filler opening of the rinse
tank
5. Wire
6. Bottom hole of the rinse
tank
(Figure
(Figure
2).
(Figure
1. Bulkhead fitting with the
wire attached
2. Bottom hole of the rinse
tank
F. Move the bulkhead fitting into position making
sure that the clear gasket seats against the interior
wall of the rinse tank
3. Secure the bulkhead fitting to the rinse tank with a
plastic flange-nut
1
1. Rinse-tank sump
2. Bulkhead fitting (installed)
4. Install a 90° fitting to the bulkhead fitting, and secure
the 90° fitting with a retaining fork
2).
1. Retaining fork
2. Bulkhead fitting
3).
5. Rotate the fitting so that it faces rearward.
4
3
1
2
Figure 3
3. Filler cap
(Figure
(Figure
4).
2
Figure 4
3. Plastic flange nut
1
Figure 5
3. 90° fitting
G014229
3).
3
G014230
(Figure
5).
G014260
2
3
Advertisement
Table of Contents
