Using Program Modes; Editing A Program - Masterflex Ismatec Reglo 78018-10 Operating Manual

Digital pump drives with advanced connectivity
Table of Contents

Advertisement

Section 3: Operation
9. Tap CONFIRM to save or DELETE to discard changes.
NOTE:
Once saved, new programs are added in alphabetical order to the bottom of the Mode Selection screen.
If there are multiple programs tapping SCROLL

Using Program Modes

Custom programs will appear in alphabetical order at the bottom of the Mode Selection screen. If there are
multiple programs tapping SCROLL
General Preparation:
Confirm the correct tubing has been selected and is properly loaded into the pump drive (for further
information see
Confirm all fluids and containers are ready.
Confirm that the tubing has been calibrated by checking that Calibration Complete
the Program Information
If required, prime the pump before operation (for further information see
page 3-7).
To use a program:
1. Select the desired program from the Mode Selection screen. The Program Run screen will be displayed.
2. Tap START
3. If required, Tap PAUSE
Continuous Mode operation.
NOTE:
Tap INFORMATION
Individual settings cannot be edited from the Program Run screen.

Editing a Program

To edit a program:
1. Tap EDIT
are multiple programs, tap SCROLL
displayed.
2. Edit the settings for the selected mode as desired. For instructions on editing individual mode settings see:
"Adding a New Program: Continuous
"Adding a New Program: Time
"Adding a New Program: Volume
3-37
Masterflex REGLO Digital Pump Drive with Advanced Connectivity
will display additional pages.
"Loading
Tubing" on page 3-3).
screen (for further information see
to begin the pump drive operation using the displayed program settings.
or STOP
to view the selected program's settings.
located next to the desired program name on the Mode Selection screen (NOTE: If there
Mode" on page 3-33.
will display additional pages.
during operation. NOTE: The pump cannot be paused during
to display additional pages). The Program Edit screen will be
Mode" on page 3-33.
Mode" on page 3-35.
"Tube
Calibration" on page 3-8).
"Priming the Pump
is displayed on
Drive" on
Masterflex

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Ismatec Reglo 78018-10 and is the answer not in the manual?

Table of Contents