Section 4: Service & Maintenance; Cleaning The Pump Drive; Software & Firmware Updates; Restore Factory Settings - Masterflex Ismatec Reglo 78018-10 Operating Manual

Section 4: Service & Maintenance
SECTION 4: SERVICE & MAINTENANCE
!
CAUTION: Replace the power cord only with one of the same type and rating.

CLEANING THE PUMP DRIVE

If required, the pump drive may be wiped clean using a soft cloth lightly moistened with either isopropyl or
ethyl alcohol.
NOTE:
• Do not use water, chlorine or any perfumed or aromatic cleaning agents on the pump drive.
• Care should be taken with the pump drive's touchscreen to avoid scratching or otherwise damaging the
surface. Do not wipe with dry or abrasive material.
• Do not operate the pump drive with water on the surface of the touchscreen.
• Any damage caused by improper cleaning will be the sole responsibility of the customer.
SOFTWARE & FIRMWARE UPDATES
Visit www.masterflex.com
updates must be downloaded onto a USB drive before installing onto the pump drive.
To install updates:
1. Insert the USB drive containing the updates into the pump drive's USB port.
2. Tap SETTINGS
3. SCROLL
4. Tap DEVICE INFORMATION.
5. Tap CHECK FOR UPDATES and follow the onscreen prompts.

RESTORE FACTORY SETTINGS

NOTE: Factory reset will erase all settings, including custom programs.
To restore the pump to the original factory defaults:
1. Tap SETTINGS
2. SCROLL
3. Tap DEVICE INFORMATION.
4. Tap FACTORY RESET and follow the onscreen prompts.
3-39 Masterflex REGLO Digital Pump Drive with Advanced Connectivity
to download the latest software and firmware updates for your device. NOTE: All
from any of the mode screens. The Settings screen will be displayed.
through the Settings screen pages to locate DEVICE INFORMATION.
from any of the mode screens. The Settings screen will be displayed.
through the Settings screen pages to locate DEVICE INFORMATION.
Masterflex