Beretta EXCLUSIVE C Installer And User Manual page 32

EXCLUSIVE
ZONES MANAGER
ZONES MANAGER
SENSOR CALIBRATION SENSOR CALIBRATION
SYSTEM RESET
SYSTEM RESET
INSTALLER INSTALLER
- select CONFIRM to conform the system reset or else CANCEL to cancel
the operation.
Note: after a reset it is necessary to carry out a new configuration of the
system; for details about this procedure, see the following section.
5.20 System configuration
b
This operation must be carried out only by professionally qualified
personnel.
When restarting after a replacement of the REC10 rather than after a
"SYSTEM RESET", the remote control displays an initial screen with
the firmware revision. Pressing "ok" a guided procedure is started for
configuring the system; select the desired options with the "up" and
"down" keys, confirming the selections made:
MULTI ZONE CONTROLLER
MULTI ZONE CONTROLLER
REC10 V01.26
PRESS ANY KEY TO PRESS ANY KEY
TO CONTINUE
- LANGUAGE selection:
ENGLISH
ITALIANO
32
INSTALL INSTALL
CONFIRM CONFIRM
CANCEL CANCEL
CONTINUE
ENGLISH ENGLISH
ITALIANO ITALIANO
- setting TIME and DATE
TIME & DATE TIME & DATE
ENTER TIME AND DATE
ENTER TIME AND DATE
12
18 / 11 / 2013
USE THE ARROWS TO MODIFY USE THE ARROWS TO MODIFY
- setting the operating mode of the REC10:
MASTER: select this option when the REC10 is also a MACHINE
INTERFACE.
- configuration selection:
FROM AKM: to reset the current boiler configuration on REC10 MASTER
and finish the operation
NEW: to set a new system configuration restoring the factory setting of
the parameters
OF CONFIGURATION
OF CONFIGURATION
Whenever a "NEW" configuration is selected, proceed as follows:
- select REC10 functionality:
ON BOARD: if the REC10 is used only as a system interface and not as
an ambient regulator
AMBIENT: if the REC10 is used as a system interface and also as an
ambient regulator of the zone where it is installed
WHERE IS THE REC10 INSTALLED?
THE REC10 INSTALLED?
- select the type of boiler INSTANTANEOUS (the boiler is the combined
variety)
INSTANTANEOUS
INSTANTANEOUS
STORAGE TANK
SELECT THE PLANT
SELECT THE PLANT CONFIGURATION
: 17
SELECT THE TYPE
SELECT THE TYPE
FROM AKM
FROM AKM
NEW
NEW
BOILER
BOILER
WHERE IS
ON BOARD
ON BOARD
AMBIENT
AMBIENT
PLANT PLANT
CH ONLY
CH ONLY
HW TANK
CONFIGURATION