Installing Wifi Module - RGBlink VENUS X1 Manual

7.3.2 Installing WIFI Module

1. Remove the 5 screws on the top cover, and move the top cover, as shown in the figure below:
2. Install the WIFI module as shown in the figure below: lock the WIFI module with 2 pieces of
2*5 flat head screws, then connect the antenna junctor and the connector with the WIFI
antenna cable.
3. Install the external WIFI antenna, as shown in the figure below:
84
Chapter 7: Appendix
Connect antenna
junctor and connector
2*5 flat head screw