RGBlink VENUS X1 Manual page 31

Hide thumbs Also See for VENUS X1:

Table of Contents

After setting, turn the knob and choose <CONNECT CARD TYPE> according to actual

connection mode. VENUS X1 support 8 kinds of connection modes, they are

Send to receiver after choose the connection mode, observe the display screen and make

sure if display image is correct. If wrong, change the connection types. Then connect the Port

D or Port U of One Sending Card to LED Screen is finished.

The setting for port D1 is same as the above setting.

Rendering is as follows:

2. Connect the Port D and Port U of One Sending Card to LED Screen

(1) First, make sure the device is in normal operation.

(2) Select the input source, for example, DVI.

(3) Connect one cable to Port D1, the other one to U1.

(4) Connect Port U1 of No.1 Sending Card to LED screen, the settings are same as Step 4 to Step 9

of "Connect the Port D or Port U of One Sending Card to LED Screen".

and

respectively.

HEIGHT

Offset (A/B) X

Offset (A/B) Y

->CONNECT CARD TYPE

120

Table of Contents