Chapter 2 Installing Your Product - RGBlink X14 User Manual

Chapter 2 Installing Your Product

1. Plug in input and connect to display
Connect signals to the product and connect the device to displays.
Tighten connector screws/locks where provided.
Make sure all devices are powered off first
2. Connect to computer
Use CAT5 or CAT6 to connect Ethernet 1 port on the communication board of X14 and computer,
Or RS232 serial cable connect UART port on the communication board of X14 and computer.
3. Connect to power
Connect IEC cable to X14 and plug into wall socket. Turn on power at wall socket.
Turn the power switch on the rear of the product to the ON position.
TFT-LCD display will show as below:
X14 User Manual
10