Table of Contents
Advertisement
The lift has twelve lubrication points: two for each cylinder and four on the lift arm:
(See the oval images below with black frames). On these images shows the lubrication
points on the lift's right side and is represented with black numbers (1-6).
On the left side of the lift are the lubrication points mirrored, and is represented in text and
images below with red numbers (7-12).
Tilt cylinder against
platform (view from
behind with platform
horizontal)
1,
2,
8
4,
10
Run down the lift in the approximate
location shown on the image to the right.
Check that the lubrication points 1 and
on the liftarm are reachable. Otherwise,
fine-tune the platform closure. Lubricate
then all points. Note: Before lubrication
of points 3 and 9: Tilt down the platform
completely.
Z/ZL 150/200/250
3,
7
Tilt cylinder against
support frame.
Start by lubricating the lift in the raised
position. (See image to the left.)
Tilt the platform a bit to avoid pressure
against the body work and lower the lift
until you get to the lubrication points 5
and 11. Lubricate all lubrication points
thereafter. To access the points 3 and 9:
Lower the platform so that there is access,
after the other points are lubricated.
Lubrication Points 4 and
to access. If so, wait with these points to
the next step.
9
10
can be difficult
7
At the third lubrication mode,
run down the lift into position
as shown to the left. Lubricate
points 4 and 10, respectively 5
and
11
5
Lift arm against the
support frame.
(Top view).
6,
Lift cylinder against
support frame.
(View from behind.)
once again.
IE-0101
5,
11
12
Hide quick links:
Advertisement
Table of Contents
