Table of Contents
Advertisement
IE-0101
The lift has twelve lubrication points: two for each cylinder and four on the lift arm:
(See the oval images below with black frames). On these images shows the lubrication
points on the lift's right side and is represented with black numbers (1-6).
On the left side of the lift are the lubrication points mirrored, and is represented in text and
images below with red numbers (7-12). On some early models are the lubrication points
4 and
10
(Tilt cylinder) on the bottom, in this case lubricate them in the first and second
mode.
Tilt cylinder against
platform (view from
behind with platform
horizontal)
1,
7
2,
8
Run down the lift in the approximate location
shown on the image to the right. Check that
the lubrication points 1 and
are reachable. Otherwise, fine-tune the
platform closure. Lubricate then all points.
Note: Before lubrication of points 3 and 9:
Tilt down the platform completely.
ZHD/ZHDL 1500/2000
3,
9
Start by lubricating the lift in the raised
position. (See image to the left.)
Tilt the platform a bit to avoid pressure
against the body work and lower the lift
until you get to the lubrication points 5
and 11. Lubricate all lubrication points
thereafter. To access the points 3 and 9:
Lower the platform so that there is access,
after the other points are lubricated.
Lubrication Points 4 and
to access. If so, wait with these points to
the next step.
7
on the liftarm
10
can be difficult
At the third lubrication mode,
run down the lift into position as
shown to the left. Lubricate the
points 4 and 10, respectively 5
and
11
once again.
2
4,
10
5,
11
Tilt cylinder and lift arm
against the support
frame. (Top view).
6,
12
Lift cylinder against
support frame.
(View from behind.)
Hide quick links:
Advertisement
Table of Contents
