Table of Contents
Advertisement
SZFT/SZFTN/SZFTS 200-160
The Tail lift has ten lubrication points: Four on the cylinders, four on the tie rods and two for
the lift arm, (See the encircled images below with black frames). In these images shows
lubrication points on the Tail lift right hand and is represented with black numbers (1-5).
On the left side of the lift are the lubrication points mirrored and are represented in text and
images below with red numbers (6-10)
NOTE! The axles between the lift arm and the support frame should not be lubricated at
all, not even initial lubrication. Therefore, lack of lubrication nipples.
The slide system has eight lubrication points, (see the section for Slide system).
5,
10
Lowering the lift in the approximate
position shown in the picture to the right.
Lubricate all points except 3 and
again.
Raise the lift to maximum (see picture at
right). Lubricate all the grease points in this
mode.
8
once
Lowering the lift to the ground as shown in
the picture to the right. Lubricate all points
except 3 and
19
1,
6
2,
7
(View from behind.)
3,
4,9
8
once again.
IE-0101
8
Hide quick links:
Advertisement
Table of Contents
