Table of Contents
Advertisement
The lift has twelve lubrication points: two for each cylinder and four on the lift arm.
Lubrication Points 1, 2, 5, 6,
(See previous page). The difference for this model is that the lubrication points 3, 4,
9
and
10
for tilt cylinders are placed on the pivot bolts (see images below, right side
shows). Even here represents in images and text black numbers (1-6) the lift`s right side
respectively red numbers (7-12) for the lift`s left side.
Tilt cylinder
against platform
(view from below).
3,
9
Tilt cylinder against
support frame
(View obliquely from the
front)
Run down the lift in the approximate
location shown on the image to the right.
Check that the lubrication points 1 and
7
respectively 3 and
otherwise fine-tune the platform closure.
Lubricate all lubrication points thereafter.
ZHD 2500
7, 8, 11
and
4,
10
Start by lubricating the lift in the raised position.
(See image to the left.)
Tilt the platform a bit to avoid pressure against
the body work and lower the lift until you get
to the lubrication points 5 and 11. Lubricate all
lubrication points thereafter. Lubrication Points 4
and
10
can be difficult to access. If so, wait with
these points to the next step.
9
are accessed,
12
are the same as the ZHD/ZHDL-1500/2000
At the third lubrication mode,
run down the lift into position as
shown to the left. Lubricate the
points 4 and 10, respectively. 5
and
11
once again.
3
IE-0101
Hide quick links:
Advertisement
Table of Contents
