Storage Controller Options; Installing A Smart Array Storage Controller - HPE ProLiant MicroServer Gen10 Plus User Manual

The DIMM slots are structured to ensure proper installation. If you try to insert a DIMM but it does not fit easily
into the slot, you might have positioned it incorrectly. Reverse the orientation of the DIMM and insert it again.
10. Install the server board assembly.
11. Install the chassis cover.
12. If removed, install the security padlock and/or the Kensington security lock.
For more information, see the lock documentation.
13. Connect all peripheral cables to the server.
14. Connect the power adapter to the server, and then secure the power adapter cord in the power cord clip.
15. Connect the power cord to the AC source.
16. Power up the server.
The installation is complete.
After installing the DIMMs, use the System Utilities > System Configuration > BIOS/Platform Configuration (RBSU) >
Memory Options to configure the memory settings.

Storage controller options

The base server supports the embedded HPE Smart Array S100i SR Gen10 Controller. To support better reliability,
security, and efficiency in the storage, install a Smart Array Gen10 type-p controller option.

Installing a Smart Array storage controller

Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Before you perform this procedure, perform the following steps:
1. Back up data on the system.
2. Close all applications.
3. Update the server firmware if it is not the latest revision.
Hardware options installation
45