Installing An Lff Drive - HPE ProLiant MicroServer Gen10 Plus User Manual

Installing an LFF drive

The LFF drives supported in this server do not require a drive caddy or a drive carrier to install. You only have to use the
drive mounting screws on the chassis.
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1. Power down the server.
2.
Disconnect the power cord from the AC source.
3. Remove the power adapter cord from the power cord clip, and then disconnect the power adapter from the server.
4. Disconnect all peripheral cables from the server.
5. If installed, unlock and remove the security padlock and/or the Kensington security lock.
For more information, see the lock documentation.
6. If the server is in a vertical orientation, position the server in a horizontal orientation.
7. Remove the front bezel.
8. Remove four drive screws from the front panel.
Hardware options installation
37