Front Panel Leds And Button; Front Panel Led Power Fault Codes - HPE ProLiant MicroServer Gen10 Plus User Manual

Front panel LEDs and button

Item Description
1 Drive activity LED
2 NIC status LED
3 Health LED
4 Power on/Standby button
and system power LED
1
This LED only reflects the status of drives that are connected to the onboard SATA port.
2
This LED reflects the status of the onboard NIC ports managed by the embedded Intel I350-AM4 Ethernet Controller.
3
When these LEDs flash simultaneously, a power fault has occurred. For more information, see Front panel LED power fault codes.
4
If the health LED indicates a degraded or critical state, review the system IML or use iLO to review the system health status.
5
Facility power is not present, power cord is not attached, or power supply failure has occurred.

Front panel LED power fault codes

The following table provides a list of power fault codes, and the subsystems that are affected. Not all power faults are
used by all servers.
Status
1
Flashing green
Off
2, 3
Solid green
Flashing green
Off
3
Solid green
Flashing green
Flashing amber
Flashing red
Solid green
3
Flashing green
Amber
Off
Definition
Ongoing drive activity
No drive activity
Linked to network
Network active
No network activity
Normal
iLO is rebooting
4
System degraded
4
System critical
System on and normal operation
Performing power-on sequence
System in standby
5
No power present
Component identification
7