Active Messages - Siemens SIMATIC ET 200SP F-TM Equipment Manual

10.2.2

Active messages

Pending faults and alarms
"Active messages" shows the currently pending faults and alarms in the F-TM ServoDrive.
Faults must be acknowledged after the cause has been corrected.
Procedure
To display the active messages, follow these steps:
1. Select the F-TM ServoDrive in the project tree and go to "Online & diagnostics".
2. In the "Diagnostics" folder, select the "Active messages" area.
Faults and alarms
Column
Fault number
Description
The F-TM ServoDrive supports the following faults.
Fault number
1000
1001
1003
1019
1032
1035
1036
1037
1039
Acknowledge faults
To acknowledge all active faults, click the "Acknowledge faults" button.
F-TM ServoDrive
Equipment Manual, 02/2020, A5E47579503-AA
Interrupts, error messages and diagnostics and system alarms
Description
Number of the fault
Description of the fault
Description
Overvoltage in the intermediate circuit
Undervoltage in the intermediate circuit
Shutdown due to overcurrent switch-off of a phase
Braking resistor/motor holding brake interrupted
Temperature measured values implausible
Permitted temperature at the motor end stage exceeded
Permitted temperature at the motor winding exceeded
Permissible temperature of the braking resistor exceeded
Connection to IQ encoder interrupted
10.2 Diagnostics
93