Siemens SIMATIC ET 200SP F-TM Equipment Manual page 58

Changing a parameter
You can directly change the values of the writable adjustable parameters (p-parameters) in
STEP 7.
You have the following options for this:
● You overwrite the current parameter value with the new value.
Or
● You select a value via the drop-down list.
Invalid values are rejected.
Note
P-parameters cannot be changed online while the drive is in operation. In this case, the
corresponding entry field is automatically disabled.
The following overview shows the display of an entry field, depending on the context and the
properties of the drive parameter:
Parameter symbols and operator controls
The following overview explains additional symbols and operator controls in the
F-TM ServoDrive engineering:
Loading drive parameters
You can synchronize all p-parameter values of your project (offline) using the "Download to
device" function.
F-TM ServoDrive
Equipment Manual, 02/2020, A5E47579503-AA
Project (offline) Parameter value can be changed and stored in the
project.
Project (offline) The parameter value is write-protected.
Project (online) Parameter value is write-protected or disabled due
to the drive status.
Drive value (online) could not be determined
Bit parameter active (1-signal)
Bit parameter inactive (0-signal)
Commissioning the
7.1 Basics
57