Configuring - Siemens SIMATIC ET 200SP F-TM Equipment Manual

Configuring

Configuration and parameter assignment
STEP 7 (TIA Portal) is available for configuring a ET 200SP F-TM ServoDrive.
You perform the following tasks with STEP 7 (TIA Portal), for example:
● You configure the F-TM ServoDrive (insertion into the project and setting the input
addresses).
● You specify the desired hardware parameters for operation of the F-TM ServoDrive.
Requirements
Hardware
● Supported interface modules: See Properties (Page 17)
● You have completed installation and wiring of the hardware. Take the potential group into
account, see section Pin assignment (Page 20).
● You have connected the PG/PC via the PROFINET interface of the CPU.
Software
● You have installed the HSP0311.
As soon as the configuration and hardware parameter assignment have been successfully
completed, you can create your user program and commission the drive.
Safety Integrated
As soon as a safety program has been created, you must perform a complete function test
based on your automation task.
For acceptance of the system, you must use the safety summary created according to the
above manual.
F-TM ServoDrive
Equipment Manual, 02/2020, A5E47579503-AA
WARNING
6
51