Replacing A Power Supply Unit - RADVision SCOPIA 400 Platform Manual

SCOPIA 400 Chassis Power Supply
R P
EPLACING A OWER
S U
UPPLY NIT
4 SCOPIA 400 Platform Guide
Figure 1-2 SCOPIA 400 Chassis Power Supply
You can remove and replace each power supply unit, even while in operation
(Hot Swap). The platform can continue to operate with a single PSU until the
second PSU is replaced.
A lever is provided on each PSU to assist in the removal of each unit.
Procedure
On the chassis rear panel, loosen the screw of the PSU you
1
want to remove, as shown in
2 Firmly grip the handle of the PSU you want to remove. Use
your other hand to brace against the chassis and provide
leverage.
Figure 1-3
3 Pull out the PSU slowly, as shown in
Figure 1-3.
Preparing to Remove a Power Supply Unit
Figure 1-4.