Diagnosis And Error Treatment - Festo SEC-ST-48-6-P01 Fitting And Installation Instructions

Stepper motor controller

Hide thumbs Also See for SEC-ST-48-6-P01:

Table of Contents

4. Commissioning

4-4

When the power supply is switched on, the green power LED

lights up. If the red fault LED Mains Supply lights up, you

must switch the unit off immediately and check the connec-

tions. (See chapter 5. Diagnosis and error treatment).

You can test the stepper motor with the Step+ and Step–

buttons. When the Step+ button is pressed, the stepper

motor turns in a clockwise direction (view of motor shaft of

Festo stepper motors type MTR-ST...). It thereby increases its

rotational speed step by step. When the Step- button is

pressed, the stepper motor turns in the opposite direction.

Please note

The settings which you make on the SEC-ST do not become

active until you press the Reset button.

Festo SEC-ST-48-6-P01-EN en 0111NH

Table of Contents