Connecting; Connecting To Power Supply; Connecting To A Computer Or Computer Network; Switching On - CAB AXON 2 Original Instructions Manual

2 Installation
2.3

Connecting

The standard available interfaces and connectors are shown in Figure 4.
2.3.1

Connecting to Power Supply

Figure 6 Connecting to power supply
Devices for 100-240 V AC
1. Check that the device is switched off.
2. Plug the power cable into the power connection socket (2).
3. Plug the power cable into a grounded socket.
Devices for 24-60 V DC
1. Check that the device is switched off.
2. Connect a suitable cable with XLR3 socket at the connector (3).
Pin 1: -
Pin 2: GND
Pin 3: 24 - 60 V
3. Connect the cable to a DC power supply.
2.3.2

Connecting to a Computer or Computer Network

!
Attention!
Inadequate or no grounding can cause malfunctions during operations.
Ensure that all computers and cables connected to the label labelling system are grounded.
 Connect the label labelling system to a computer or network by a suitable cable.
For details of the configuration of the individual interfaces  Configuration Manual.
2.4

Switching on

When all connections have been made:
 Switch the labelling system on at the switch (1).
The labelling system performs a system test, and then shows the system status Ready in the display (11/Figure 1) .
The pressure rollers move in to the put-in position.
1
2
1
3
9