Table of Contents
Advertisement
Configuration
6
20
i
Note!
In that chapter are described the specific applicator parameters of the menu Labelling only.
For more information about the configuration Configuration Manual of the printer.
Start menu.
Select Setup > Labelling.
Parameter
Peel-off position
Teach-in product
Eject tube
Opening width
Check diameter
Table 4
Teach-in product
Select Teach-in product.
The display shows Step 1/2 Remove tube.
Remove the tube from the applicator and select Continue.
After a short applicator movement the display shows Step 2/2 Insert tube.
Insert a tube and select Continue.
After a next applicator movement the display shows Product successfully taught-in.
If the result is out of the specification an error message will appear.
Select Continue.
Meaning
Shift the position of the dispensed label relative to the dispensing edge.
The setting can also be adjusted by the software.
The settings of configuration and software are added together.
Function to teach the applicator to the tube diameter.
On: The tube will be ejected after labelling
Off: The tube will be left in the labelling area after labelling
Setting the distance between the transport rollers and pressure rollers
for tube input
Checking the tube diameter before labelling
Parameters of the Setup > Labelling menu
20
Default
0.0 mm
Off
1
Off
Advertisement
Table of Contents
