Table of Contents
Advertisement
5
Operation
5.2
Standard Operation
Warning!
!
Risk of injury by rotating parts!
During operation, rotating parts are freely accessible.
Ensure that people's clothing, hair, jewelry etc. do not come into contact with the exposed rotating parts.
!
Attention!
Peel-off mode must be activated in the software.
This is done with the "P command" in the direct programming, Programming Manual.
Figure 17
Operation
Send a print job.
Insert the first tube.
Press
.
The tube will be pressed against the transport rollers. The first
label will be printed and applied onto the turning tube.
After about two turns the locking clamps will be opened.
Depending on the configuration the tube will be ejected or left
in the labelling area.
Remove the tube.
Insert the next tube.
Press
again to start next cycle.
19
Advertisement
Table of Contents
