Table of Contents
Advertisement
4
Loading Material
4.2.2
Inserting the Media into the Printhead and Fixing the Liner at the Rewinder
Inserting the media into the printhead and fixing the liner at the rewinder
Figure 13
1. Turn the lever (5) counterclockwise to lift the printhead (3).
2. Fold down the pinch roller (8).
3. Remove labels from the first 100 mm of the liner.
4. Guide the label strip over the rewinder (10), through the label sensor (9), around the dispense plate (1) and the
rewind assist roller (7) to the rewinder (10).
5. Hold the rewinder (10) firmly and turn the knob (11) clockwise until it stops.
6. Push the liner under a bracket (6) of the rewinder (10) and align the outer edge of the strip to the media roll.
7. Turn knob (11) counterclockwise until it stops.
The rewinder is fully spread, thus gripping the liner firmly.
8. Turn rewinder (10) counterclockwise to tighten the liner.
9. Swing the pinch roller (8) against the rewind assist roller (7).
10. Turn the lever (5) clockwise to lock the printhead.
11. Fold up the applicator.
4.2.3
Removing the Wound Liner Roll
Cut the liner.
Hold rewinder (10) firmly and turn knob (11) clockwise.
The rewinder spindle relaxes and the wound roll is released.
Remove the wound roll from rewinder (10).
1
2
3
4
5
7 8
9
6
10
11
15
Advertisement
Table of Contents
