Maintenance And Troubleshooting - Pro-Form HIIT TRAINER LITE 5.9 User Manual

MAINTENANCE AND TROUBLESHOOTING

MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the trainer is used. Replace
any worn parts immediately.
To clean the trainer, use a damp cloth and a small
amount of mild soap. IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
The console requires activation. If you have not
activated the console, see assembly step 20 on
page 15.
If the console does not turn on, make sure that the
power adapter is fully plugged in.
If the console does not display your heart rate when
you hold the handgrip heart rate monitor, or if the dis-
played heart rate appears to be too high or too low, see
step 5 on page 20.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first unplug the power adapter.
Next, remove
the four
indicated
M4 x 16mm
Screws (93)
and the Center
Shield Cover
(31).
Next, turn the Crank Pulley (44) until a Pulley Magnet
(8) is aligned with the Reed Switch (60). Then, slightly
loosen the two M4 x 12mm Flange Screws (94), slide
the Reed Switch slightly closer to or away from the
Pulley Magnet, and retighten the Flange Screws.
60
94
8
Then, plug in the power adapter and turn the Crank
Pulley (44) for a moment. Repeat these actions, if
necessary, until the console displays correct feedback.
Then, reattach the center shield cover.
25
31
93
44