Maintenance And Troubleshooting - Pro-Form Trainer R14 User Manual

MAINTENANCE AND TROUBLESHOOTING

MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the rower is used. Replace
any worn parts immediately. Use only manufacturer-
supplied parts.
To clean the rower, use a damp cloth and a small
amount of mild detergent. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
For best results, clean the rail, the seat carriage, and
the carriage rollers daily.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power adapter is fully plugged in.
If you are having problems connecting the console
to a wireless network, or if you are having problems
with your iFIT account or iFIT workouts, go to
support.iFIT.com.
If a replacement power adapter is needed, see the
front cover of this manual. IMPORTANT: To avoid
damaging the console, use only a manufacturer-
supplied regulated power adapter.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
See EXPLODED DRAWING B on page 31. Locate
the Right and Left Shields (7, 8). Remove the four
M4 x 19mm Screws (69) and the nine M4 x 16mm
Screws (68) from the Right and Left Shields. Then,
gently remove the Right and Left Shields.
Next, locate the Reed Switch (47). Turn the Left
Flywheel (4) until a Magnet (85) is aligned with the
Reed Switch. Then, slightly loosen the two indicated
M4 x 19mm Screws (69), slide the Reed Switch slightly
closer to or away from the Magnet, and then retighten
the Screws.
Turn the Left Flywheel (4) so that the Magnet (85)
passes the Reed Switch (47) repeatedly. Repeat these
actions until the console displays correct feedback.
When the reed switch is correctly adjusted, reattach
the parts that you removed.
26
4
47
85
69