Maintenance And Troubleshooting - Pro-Form HYBRID TRAINER PFEL03721C.0 User Manual

MAINTENANCE AND TROUBLESHOOTING

MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the hybrid trainer is used.
Replace any worn parts immediately. Use only
manufacturer-supplied parts.
To clean the hybrid trainer, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power adapter is fully plugged in.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first unplug the power adapter.
Remove the
two M4 x 16mm
Screws (84) from
the Rear Access
Cover (26), and
then remove the
Rear Access
Cover.
26
84
Next, locate the Reed Switch (60). Slightly loosen the
two M4 x 16mm Screws (84).
93
48
Next, rotate the Large Pulley (48) until a Pulley Magnet
(93) is aligned with the Reed Switch (60). Slide the
Reed Switch slightly toward or away from the Pulley
Magnet. Then, retighten the M4 x 16mm Screws (84).
Plug in the power adapter and rotate the Large Pulley
(48) for a moment. Repeat these actions until the con-
sole displays correct feedback.
When the reed switch is correctly adjusted, reattach
the rear access cover and plug in the power adapter.
25
60
84