Table of Contents
Advertisement
Preparing the Machine
WARNING
While you are maintaining or adjusting the
machine, someone could start the engine.
Accidentally starting the engine could
seriously injure you or other bystanders.
Remove the key from the ignition, engage
parking brake, and pull the wire(s) off the
spark plug(s) before you do any maintenance.
Also push the wire(s) aside so it does not
accidentally contact the spark plug(s).
Perform the following before servicing, cleaning, or
making any adjustments to the machine.
1.
Park the machine on a level surface.
2.
Shut the wide-distribution impeller-gate for the
spreader and shut off the sprayer-pump switch.
3.
Shut off the engine and remove the key.
4.
Engage the parking brake.
5.
Wait for all moving parts to stop allow the engine
to cool before servicing, storing, or making
repairs.
6.
Disconnect the spark-plug wire
Figure 58
1. Spark-plug wire
Lubrication
Lubricating the Grease
Fittings
Service Interval: Every 100 hours
Grease type: National Lubricating Grease Institute
(NGLI) grade #2 multi-purpose gun grease.
1.
2.
(Figure
58).
1. Wheel bearings (2)
2. Kingpin pivots (2)
g258042
3.
4.
5.
51
Prepare the machine for maintenance; refer to
Preparing the Machine (page
Wipe the grease fittings clean with a rag
59).
Figure 59
Connect a grease gun to the fittings
Pump grease into the fittings until grease begins
to come out of the bearings.
Wipe up any excess grease.
51).
(Figure
g027437
3. Front axle pivot
4. Steering control pivot
(Figure
59).
Advertisement
Table of Contents
