Parameter
Metering
Configuring the Mode of Brightness Priority
Procedure
1. Do one of the following:
• On your web user interface, go to Setting > Camera > Exposure.
• On your VCS:
On your VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Camera > Exposure.
On your VC200, go to More > Setting > Video & Audio > Exposure.
• On your CTP20, tap Setting > Camera > Exposure.
2. Select Brightness Priority from the Exposure drop-down menu.
3. Configure and save the following settings:
Parameter
Brightness
Flicker
Description
Configure the value of metering.
• Average
• Central
• Bottom
• Top
Default: Average.
Description
Configure the value of brightness.
Note: the valid value is from 0 to 14 and the
default value is 6.
Configure the value of camera flicker
frequency.
The supported types are as follows:
• 50 Hz
• 60 Hz
The indoor lights powered by a 50Hz or 60Hz
power source may produce a flicker. You can
adjust the camera flicker frequency according
to the power source that the light is powered
by.
Default: 50 Hz.
| Configuring Camera Settings | 161
Configuration
Method
Web user interface
Endpoint
CTP20
Configuration Method
Web user interface
Endpoint
CTP20
Web user interface
Endpoint
CTP20