VarioCooking Center WHITEFICIENCY Series Original Technical Instructions page 109

Heating system: general
Installation and description
2
D
Important points!
● When installing, always use the truing bushes delivered in the replacement kit.
● There must be a torque of 4 Nm. Fig. 3.
● Read the installation instructions supplied with the kit carefully.
● The heating element must be in contact with the bottom of the pan via the graphite sheet.
● The thermocouple must be properly centred and in contact with the bottom of the pan.
● After an exchange of the heating element it is customary to recalibrate the unit, or even to also
make an allocation. (See Chapter Heating system > Allocation/calibration).
Line Units
VCCM All
VCCWE
3
Serial number (starting from)
ExxXH1009xxxxxxx
Fig. 2, Heater
A Mica insulation plate
A
B "Thick Film" heater
C Electrical contact
B
D Thermocouple location
E Mounting stud passage
C
Features:
P = 1400W or 2286W (depend on model)
Available in 3 voltages:
200VAC - 230VAC - 445VAC
E
Sw
IX.03
Heating system module
4 Nm
Revision
v03 • July-2016 • Hen