Programming; Basic Functions - BFT CDS 1.3 Installation And Operation Manual

7. PROGRAMMING

To access programming, press button F for 2 seconds.
Programming is divided into 3 levels.
To go to the next level keep key F pressed and press the + key (Sequence 1-2-3-1.......).
After selecting the level wanted, press push button F to display the functions available in consecutive order. Each time F is pressed it corre-
sponds to a function ( -  -  - .....)
With the function set, use the
The changes made to the parameters are active immediately but will be saved when exiting the menu, selecting the ST function with key F.
PLEASE NOTE: If there is a black out when programming, all changes will be lost.
x 2"
F
1st level
programming
+
+
F
2nd level
programming
+
+
F
3rd level
programming
+
+
F
Control unit

7.1 BASIC FUNCTIONS

+ -
or key to change the values of the parameters (
Selects each single
F
1st level function
(see table par.6.2)
Selects each single
F
2nd level function
(see table par.6.3)
Selects each single
F
3rd level function
(see table par.6.4)
Example:
Selecting Output2 on bollard closed:
A
B
+
x 2"
+
F F
nd
2 level
+
: ---... /
Changes the values
-
+
of each single 1st
level function
(see table par.6.2)
F
Changes the values
-
+
of each single 2nd
level function
(see table par.6.3)
F
Changes the values
-
+
of each single 3rd
level function
(see table par.6.4)
F
C D
x 5 x 4
F +
 =bollard closed
- 25 -
-
: ...---).
-
F
F
"ST" function
Exit and save
programming
E
x 3
F

EN
+