Table of Contents
Advertisement
Human Interface Module
E
n
a
b
l
e
d
7
3
5
.
0
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Regenerative DC Bus Supply Operation
HIM Description
When the converter mounted HIM is supplied, it will be connected
as Adapter 1 and visible from the front of the converter.
The display panel provides a means of programming the 1336
REGEN Converter and viewing the various operating parameters
Important: If a Control Panel HIM is connected to the 1336
REGEN Converter, only the Start key and Stop key
on the control panel will be functional — The Start
key will send an Enable command to the Converter,
the Stop key will send a Not Enable command to the
Converter.
ATTENTION: When a HIM is not supplied on
!
enclosed NEMA Type 1 (IP 20) 1336 REGEN
Controllers, the blank cover plate (option HAB) must
be installed to close the opening in the front cover of
the enclosure. Failure to install the blank cover plate
allows access to electrically live parts which may result
in personnel injury and/or equipment damage.
When a HIM is supplied with enclosed NEMA Type 1
(IP 20) 1336 REGEN Converters but has been
removed from its mounting cradle for remote
operation, the blank cover plate must be installed in its
place.
HIM Removal
For handheld operation, the module can be removed and located
up to 10 meters (33 feet) from the 1336 REGEN Converter.
ATTENTION: Some voltages present behind the 1336
!
REGEN Converter front cover are at incoming line
potential. To avoid an electric shock hazard, use extreme
caution when removing/replacing the HIM.
HIM Operation
ESCape
When pressed, the escape key will cause the programming system to go back one
level in the menu tree.
SELect
Pressing the select key alternately causes the top or bottom line of the display to
become active. The flashing first character indicates which line is active.
Increment/Decrement
These keys are used to increment and decrement a value or scroll though different
parameters.
Enter
When pressed, a parameter will be selected or a parameter value will be entered into
memory. After a parameter has been entered into memory, the top line of the display
will automatically become active, allowing another parameter to be chosen.
2–23
Advertisement
Table of Contents
