Table of Contents
Advertisement
Troubleshooting
Status
FAULT
DS1
Fault & Code No.
On
Illegal Drv.
Type
F
34
On
SW Malfunction
F
35
On
Host/DSP Com Err
F
37
On
PwrUp DspCom Err
F
38
On
EE Checksum
F
39
On
Pwr Up Marker
F
40
On
Unknown Error
F
41
On
No Entry
F
42
On
Clear Faults
F
43
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
ENABLE
STATUS
COM
DS3
DS2
DS4
N/A
N/A
Flashing
N/A
N/A
Flashing
N/A
N/A
Flashing
N/A
N/A
Flashing
N/A
N/A
Flashing
N/A
N/A
Flashing
N/A
N/A
Flashing
N/A
N/A
Flashing
N/A
N/A
Flashing
Indicates
The power structure is not
supported.
Software error.
Host processor unable to
communicate with the Converter
SCANport.
Host processor unable to
communicate with the Converter
SCANport.
1336 REGEN Converter parameter
database is corrupt.
Fault queue text.
Fault queue text.
Fault queue text.
Fault queue text.
Troubleshooting
4–5
Action
1. Check that the Converter
Control Board and Gate Driver
Board are matched and
correspond to the Converter
frame size.
2. Reset and re-enable by:
a.Exiting to the EEProm Mode.
b. Resetting defaults.
c. Verifying that P1 is set to the
correct operating mode.
d. Resetting the Converter.
If the fault occurs again, replace
the Converter Control Board.
Reset and re-enable the Converter.
If the fault occurs again, replace the
Converter Control Board.
Reset and re-enable the Converter.
If the fault occurs again, replace the
Converter Control Board.
Reset and re-enable the Converter.
If the fault occurs again, replace the
Converter Control Board.
Reinitialize Converter parameters
or:
1. Recall values.
2. Save values.
3. Reset and re-enable the
Converter.
If the fault occurs again, replace the
Converter Control Board.
N/A
Reset and re-enable the Converter.
If the fault occurs again, replace the
Converter Control Board.
N/A
N/A
Advertisement
Table of Contents
