Allen-Bradley 1336 REGEN Series User Manual page 93

3–40 Regenerative Brake Operation
Programming
F a u l t S e l e c t 1
2 7
X X X 1 1 1 0 0
27
Parameter No.
Bits
Display Units
Read/Write
Parameter Type
XXX11100
Factory Default
N/A
Min/Max Value
N/A
Drive Units
I M D s p l a y P r m
H i
5 2 8
Parameter No.
Number
Display Units
Read/Write
Parameter Type
Factory Default
Min/Max Value
Drive Units
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Fault Select 1
This parameter enables or disables faults as defined by the first (5) bits of a (16) bit word. The
[Fault Select1] parameter may be set while the 1336 REGEN Converter is enabled.
Bit 4 Bit 3 Bit 2
HIM Default Display Parameter
This parameter sets which of the previous parameters will be displayed after 1336 REGEN
Converter power-up. The [HIM Display Param] parameter may be set while the 1336 REGEN
Converter is enabled.
28
5
1/32
N/A
Bit 1 Bit 0
0 = SCANport 1 Timeout Disabled
0 = SCANport 2 Timeout Disabled
0 = Phase Mismatch Fault Disabled
0 = Open Precharge Fuse Fault Disabled 1 = Open Precharge Fuse Fault Enabled
0 = PLL Fault Disabled
1 = SCANport 1 Timeout Enabled
1 = SCANport 2 Timeout Enabled
1 = Phase Mismatch Fault Enabled
1 = PLL Fault Enabled