Allen-Bradley 1336 REGEN Series User Manual page 46

Programming
O p e r a t i o n a l M o d e
X X X X 0 0 0 0 1
Parameter No.
bits
Display Units
Read/Write
Parameter Type
XXXXX000
Factory Default
Regen Brake Mode
N/A
Min/Max Value
000 = 0
Drive Units
bin
R a t e d C u r r e n t
0 0 0 A M P S 2
.
Parameter No.
Amps
Display Units
Read Onl
Parameter Type
1 = 0.1A
Drive Units
L i n e C u r r e n t
+ 1 0 0 % 3
Parameter No.
%
Display Units
-200/200
Min/Max Value
Read Only
Parameter Type
100 = 4096
Drive Units
P e a k L o a d
4
+ 1 0 0 %
Parameter No.
%
Display Units
-200/200
Min/Max Value
Read Only
Parameter Type
100 = 4096
Drive Units
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Operational Mode
Sets the 1336 REGEN Line Regeneration Package mode of operation. The modes are defined
by the last (3) bits of a 16 bit word. To set the mode, first stop the 1336 REGEN Converter, set
the mode, then re-enable the converter.
1
Bit 3 Bit 2 Bit 1 Bit 0
Important: If the [Operational Mode] is reset while the 1336 REGEN Converter is enabled,
a System Mode Change Fault will occur. Issuing a reset command will clear the
fault and reset the converter.
Rated AC Line Current
Displays the rated AC line current of the 1336 REGEN Converter.
2
y
AC Line Current
Displays the actual I
indicate motoring — Negative values indicate regeneration.
3
Peak Load
Displays the peak motoring or regenerating current in percent of rated AC current. The peak
value is held for five seconds. Positive values indicate motoring — Negative values indicate
regenerating.
4
Regenerative DC Bus Supply Operation
0 = Regen Brake Mode
0 = Fixed DC Bus Mode
0 = 460VAC Input Line Voltage
0 = Fixed DC Bus
0 = Voltage Gain
AC line current in percent of rated AC line current. Positive values
q
2–29
1 = Regen DC Bus Supply Mode
1 = DC Bus Trim Mode
1 = 380VAC Input Line Voltage
1 = Scheduled DC Bus
1 = Voltage Gain