Verify The Operating Environment; Protect Against Electrostatic Discharge (Esd) - Keysight Technologies M937 A PXIe Series Service Manual

Tests, Adjustments, and Troubleshooting
Before You Begin
Equipment
3.5 mm (-m- to -m-)
3.5 mm (-f- to -f-)
2.4 mm (-m-) to 3.5 mm
(-m-), (Qty 2)
3.5 mm (-m- to -f-), 
10 dB fixed attenuator, (Qty
2)
5/16 inch (8 mm), open-end
torque wrench
Cable removal tool
a. P = Performance tests, A = Adjustments
b. Refer to "Get the Hardware Required for your GPIB Instruments" on page
c. Required only if using an embedded controller. Refer to
page 2-5.
d.
Included in the 85052B/D calibration kits.
e. Included with the M937xA shipment.
Get the Hardware Required for your GPIB Instruments
The hardware required to connect your GPIB instruments to the network
analyzer depends on the type of controller you use.
- If using an embedded controller, you need an M9036-31301 GPIB Micro 2
- If using a remote controller, you need a GPIB card for the PC.

Verify the Operating Environment

For Operating Environment information, refer to the online Data Sheet at
http://literature.cdn.keysight.com/litweb/pd f/M9370-90002.pd

Protect Against Electrostatic Discharge (ESD)

For information on
to the online Startup Guide at
http://literature.cdn.keysight.com/litweb/pd f/M9370-90001.pd f
Keysight M937xA PXIe Service Guide
Critical Specifications
Adapters
³
Return Loss: 32 dB
³
Return Loss: 32 dB
³
Return Loss: 24 dB
Attenuators
Accuracy: ±0.5 dB
Freq: DC to 26.5 GHz
1.13 N.m (10 in-lb) setting (for
semi-rigid cables and 50 ohm
loads)
N/A
cable.
protecting against electrostatic discharge (ESD)
Recommended
Model or Part
Number
83059A
83059B
11901A
8493C
Option 010
Tools
N/A
e
5002-3361
2-5.
"Get the Hardware Required for your GPIB Instruments" on
Alternate Model
Use
Number
P, A
d
85052-60014
P
d
85052-60012
Any equivalent P
Any equivalent P
N/A P, A
N/A P, A
f.
, refer
2-5
a