Keysight Technologies M937 A PXIe Series Service Manual page 22

Tests, Adjustments, and Troubleshooting
Information in This Chapter
Section Title
Non-Standards Compliant Verification
Preliminary Checks
System Verification
a
Performance Tests
b
Adjustments
Troubleshooting
a. These performance tests are included in the analyzer's firmware for Options 897 or 898.
b. These adjustments are included in the analyzer's firmware on all models and options.
2-2
Summary of Content
The Non-Standards Compliant process of verifying your network
analyzer.
Performing the Operator's Check.
Checking your test cables.
NOTE Perform these checks before performing system verification.
What the system verification does.
How to perform the verification test.
How to interpret the results.
A brief summary of each performance test:
-Source Power Accuracy
-Source Maximum Power Output Test
-Source Power Linearity Test
-Frequency Accuracy Test
-Trace Noise Test
-Receiver Compression Test
-Noise Floor Test
-Calibration Coefficients Test
-Dynamic Accuracy Test
Setups and procedures for adjusting your network analyzer:
-10 MHz Frequency Reference Adjustment
-Source Adjustment
-Receiver Adjustment
A list of troubleshooting suggestions.
Keysight M937xA PXIe Service Guide