Stihl TS 440 Service Manual page 45

Wire with terminal socket (12) must run underneath
N
the wiring harness (7).
Press the wires of the wiring harness (7) into the
N
guides (arrows) with the aid of the wiring tool. The
black wire must run underneath the blue wire.
Align ferrite sleeves (13, 14) as shown in the drawing.
N
Coat support foot (3) with STIHL press fluid.
N
Insert support foot (3) into guides of air baffle (5).
N
Fit filter cover (2) and place support foot (3) in
N
position on tank housing.
Insert screws (1) and tighten.
N
Align plug.
N
Install the electronic module, @ 14.3.
N
Fit fan cover, @ 11.3.
N
Fit shroud, @ 16.3
N
TS 440 43