Installing The Connector - Stihl TS 440 Service Manual

Remove connector (7) and attached parts.
N
Slowly release brake lever (6).
N
7.3

Installing the connector

6
7
Actuate the brake lever (6) and hold it.
N
Push locking pin (10) 4130 893 7800 through the
N
holding-down clamp (11) as far as it will go. The brake
lever underneath the holding-down clamp (11) will be
immobilized.
Release the brake lever (6).
N
Place connector (7) and attached parts in position
N
against the clutch drum and push on over the studs.
Screw on nuts (5).
N
Actuate the brake lever (6) and hold it there.
N
Remove locking pin (10) 4130 893 7800.
N
Slowly release brake lever (6).
N
9
8
Push the grommet (9) into the support (arrow).
N
Plug white plug (8) into electronic module. The
N
plug (8) engages.
TS 440
10
11
Fit cover (4). The cover (4) audibly engages.
N
Insert screw (3) and tighten.
N
Push hose (2) and hose clip (1) onto water
N
connection.
Close hose clip (1).
N
Install the rear V belt, @ 4.3.
N
Install "starter cover with rewind starter", @ 4.3.
N
Fit guard, @ 4.3.
N
13