Installing The Generator - Stihl TS 440 Service Manual

3
8
6
Unscrew screw (4) and screws (2) with
N
screwdriver 5910 890 2301.
Lift up the generator (3).
N
Pull ground wire (8) and generator wire (6) out of the
N
guides in the cable holder (5).
Pry out cable holder (5).
N
Remove generator (3).
N
12.3

Installing the generator

3
5
Place generator (3) in position.
N
Pass generator wire (6) through opening (arrow).
N
Insert generator wire (6) and ground wire (8) into the
N
cable holder (5).
Coat cable holder (5) with STIHL press fluid.
N
Press cable holder (5) into the opening (arrow).
N
30
2
4
5
6
8
3
6
5
Pass generator wire (6) behind strap (arrow) of cable
N
holder (5). The generator wire (6) should lie snugly.
Route the ground wire (8) so that the crimped side
N
faces the screw head.
Place generator (3) in position. The cable holder (5)
N
is located under the generator.
6
8
Push ground wire (8) and generator wire (6) into the
N
guides in the cable holder (5).
Coat screw (4) and screws (2) with thread-locking
N
adhesive.
Insert and tighten screw (4) and screws (2).
N
Pass generator wire (6) through grommet (7).
N
Push insulating hose (1) onto generator wire (6).
N
Connect the plug connection.
N
Slide insulating hose (1) over middle of plug
N
connection.
Insert grommet (7).
N
8
3
2
4
1
6
9
7
TS 440